Share:
Notifications
Clear all

Need a Bit of Help

(@murray)
Active Member

I am about to start the SMT to manual conversion shortly. I have the BGB, and the instructions from Monkey Wrench. What I could use is a few pictures of the connection points at the transmission area and clutch slave cylinder. The various brackets and the actuator link, for example, are shown, but in blown-up form only. Some pictures would be worth ”a thousand words”. Thanks for any pictorial assistance.

This topic was modified 4 years ago by Murray
Quote
Topic starter Posted : January 7, 2020 3:32 pm
dev
 dev
(@dev)
Just a member.

 Im currently helping a member with a transmission repair.  The transmission is now in the car but the top end needs to be put back together. I should have some picture for you soon.  

 

 

ReplyQuote
Posted : January 8, 2020 10:35 am
(@murray)
Active Member

Thanks, Dev. That will be very helpful.

ReplyQuote
Topic starter Posted : January 8, 2020 11:21 am
Share: